Code : SM 09
These are high powered magnets that do not require any electric power. Iron impurities are separated automatically. They are strong enough to handle and withstand rough handling. They operate on 1 HP Motor. Manual operation possible in case of power failure. Completely enclosed to avoid dusting & pollution.

Code : SM 10
These magnetic separators are utilized for clearing and purifying free flowing powders and granular material or concentrate and reclaim products in such materials. This also saves the valuable equipments like grinders, crushers, rolls, etc. against tramp iron. They can be installed inside closed chutes, at outlets of chutes and hoppers, or where materials discharge from feeders and conveyors. Double drum and triple drum magnetic separators are ideal for separating ferrous metal from material such as shredded cars, slag, crushed ore and ash at mass burn plants, in foundries recycling plastic, aluminum and glass. Ferrous metal is magnetically drawn out of the material feed, held against the revolving shell, and released when it reaches a discharge point beyond the magnetic field.

Code : SM 11
Permanent magnetic pulleys are important magnetic products which are used as head pulleys in belt conveyors for removing ferrous contaminants from material flow. The magnetic field generated by the pulley attracts the ferrous fines which are held to the belt until it reaches the underside. After passing out of the the magnetic field the ferrous material is collected separately into a chute or bin. The cleaned material is discharged normally over the pulley in a vertical drop. The magnetic pulleys are available in various sizes to meet requirements of most conveyor system applications. The magnetic pulley is used for various applications like Waste recovery, feed & grain, mining and recycling applications.

Code : SM 12
Hump magnetic separators are used to remove ferrous contaminants iron nuts, bolts, wire, banding etc. from the conveyed material. With the hinged doors, cleaning of the magnetic surface is quick and easy. The unit can be mounted directly in the air stream with the square to round transitions which can be provided. These magnets consist of two Plate Magnets which are hinged and gasketed to the rugged steel housing. These plate magnets can be unlatched and swing open for quick manual cleaning. Humps are recommended if the flow is vertical, or if the angle of the chutes is more than 70 degrees. If product flow is light, on magnet in the half hump model may provide sufficient separation.
NOTE: Custom-made humps to suit any special requirements can supplied.